SCSIRAIDGURU’s World
Cisco Virtual Lab Simulations
SRG

SCSIraidGURU’s World

VRF with EIGRP

In this diagram we have two VRF groups HR and ACCT.    I used VRF to isolate HR department traffic from ACCT department traffic.  

I setup loopbacks on each router that are in HR or ACCT.  All routers can ping out to the real world. 172.16.1.1 is my 60E.  192.168.1.240 is my workstation for TFTP.  I use redirects to build these pages.   I used ip tftp source-interface g0/x to allow the TFTP traffic out.  

EIGRP doesn’t allow default-information originate always.  I setup ip route vrf routing commands for 0.0.0.0 0.0.0.0 as one test to get to the 60E and my workstation.  A setup a second ip route vrf HR and ACCT with 172.16.1.0 255.255.255.0 and another set with 192.168.1.0 255.255.255.0 to get out.   Either would work but for completeness, I did both.

iosv-6:
ip tftp source-interface GigabitEthernet0/1
ip route vrf ACCT 172.16.1.0 255.255.255.0 192.168.64.17
ip route vrf ACCT 192.168.1.0 255.255.255.0 192.168.64.17
ip route vrf HR 172.16.1.0 255.255.255.0 192.168.48.13
ip route vrf HR 192.168.1.0 255.255.255.0 192.168.48.13

On iosv-1, I have IP route vrf to bring traffic back into VRF from the 60E.

ip route 0.0.0.0 0.0.0.0 172.16.1.1
ip route 192.168.48.0 255.255.255.224 GigabitEthernet0/2
ip route 192.168.64.0 255.255.255.224 GigabitEthernet0/3
ip route vrf ACCT 0.0.0.0 0.0.0.0 172.16.1.1 global
ip route vrf HR 0.0.0.0 0.0.0.0 172.16.1.1 global

Close Menu